TP series amplifier 2 channel 4 channel TP 2.150 TP 4.100 TP 2.150 & TP 4.100 New TP series amplifier is the hybrid amplifier adopts two or four vacuum tubes in preamplifier stages, which are decided to be used as the best matched vacuum tube with TP series amplifiers after a long term listening test and the making many comparison tests of A tube and B tube. Finally current 6N3 triode tube was selected. Consequently its combined operation of vacuum tubes and well designed transistor circuit layout could achieve the warm and smooth sounds that compensated the hard and cold sounds of which a transistor amplifier usually reproduces. As the first step for the future line-up of tube amplifiers, we released high power 2ch and 4ch amplifiers. They can perform continuous reproduction abilities of warm and smooth sounds without distortions to the limit without any changes. The bodywork of TP amplifiers succeeded to the RE series body construction image adopts the aluminum thick plates on both sides and the injection molded thick panels on the top and the bottom. They attained not only the functional beautifulness but also the good ability of the heat dissipation. There is a atmosphere can imagine the existing of masterpiece on its appearance. TP 2.150 Stereo Amplifier TP 2.150 Stereo Amplifier 150 W x 2 TP 4.100 4 channel Amplifier TP 4.100 Stereo Amplifier 100 W x 4 Specifications TP 2.150 TP 4.100 Power Output 14.4V/4ohm 1KHz @0.3% THD 14.4V/2ohm Frequency response S/N ratio Stereo separation Idle current Remote voltage Input impedance Input sensitivity Crossover frequency (HP) Fuse type Dimensions: WxLxH mm 150 W x 2 220 W x 2 20-80 KHz >95 dB 75 dB 1.3 A 10-17 V 20 Kohm 0.2-4 V 50-200 Hz 15 A x 4 452 x 200 x 59 100 W x 4 130 W x 4 20-80 KHz >90 dB 75 dB 2 A 10-17 V 20 Kohm 0.2-4 V 50-200 Hz 15 A x 4 452 x 200 x 59

FT TRADING LTD. 1882-4 Yawata-cho Iida-shi Nagano Japan TEL +81-265-23-5221 FAX +81-265-24-2100

(c)Copyright 2007 FT TRADING LTD. All rights reserved